Clean the sink and water ring

At the beginning, disconnect the power supply of the water ring vacuum pump and drain the water in the tank. Then, disassemble the water ring part and clean it thoroughly. Gentle cleaning agents and soft brushes or sponges can be used to clean the sink and water ring. Be careful not to use corrosive cleaning agents to avoid damaging the surface of the parts. After rinsing and cleaning, ensure that the sink and water ring are completely dry.

Clean the water pipes and filters

Check for blockages or accumulated dirt in the water pipes and filters. If there is dirt, you can use a soft brush or water gun to clean the water pipe and filter. Ensure that all water pipes and filters are dry before reinstalling.

Check and replace seals

Regularly inspect the seals of the water ring vacuum pump, such as O-rings and gaskets. If aging or damage is found in the seals, replace them with new ones in a timely manner to ensure good sealing performance.

Clean the air inlet and outlet

Check and clean the inlet and outlet of the water ring vacuum pump. These mouths often accumulate dust, impurities, and oil stains. Use a soft brush or compressed air to clean the air inlet and outlet, and ensure that they are unobstructed.

Regular maintenance and upkeep

Establish a regular maintenance and upkeep plan, regularly inspect and clean the water ring vacuum pump. Lubricate and replace parts according to the manufacturer's recommendations to maintain the normal operation of the pump.

Please note that when cleaning the water ring vacuum pump, caution should be exercised and relevant AN regulations should be followed. If unsure about the cleaning process, it is recommended to consult the manufacturer or professional technicians for advice. Proper cleaning and maintenance will help maintain stable performance and extend the service life of water ring vacuum pumps.